Description

220V High Pressure Voltage Pulse Igniter Fuel Waste Oil Burner Nozzle Combustion Item Description Product details: Nozzle Material: Bronze Hole Diameter: 0.5mm 0.8mm 1.0mm 1.2mm 1.5mm 2.0mm 2.5mm 3.0mm 3.5mm 4.0mm Product overview: Brass Siphon Fuel Oil Burner Nozzle is a low pressure Air Atomizing can spray atomizing the best in low pressure air atomizing nozzle. Widely used in diesel engines, heavy oil, waste oil, animal oil and vegetable oils, alcohol-based fuel-burner system, and for kerosene, atomizing oil. Product characteristics: · The use of compressed air to swirl inside the tubes and mix the atomized impact droplets. · It can produce tiny micro particle size mist particles under low pressure and low volume conditions. · Can control air flow and pressure to adjust spray flow, angle and granularity size. · Since the nozzle fluid passage is large, it has a good anti-clogging effect. · In heavy oil, waste oil burner, oil liquid viscosity and other applications of atomizing effect is very good. · Working pressure is 0-10/kg/cm2, different flow capacity needs different from filter screen Flow capacity range is 1.5-1.7 L/h, need a 45um oil filter screen Flow capacity range is 1.89-3.78 L/h, need a 75um oil filter screen Flow capacity range is 4.76-5.10 L/h, need a 125um screen oil filter Flow capacity range is 5.68-41.64 L/h, need a 140um oil filter screen Flow capacity about 45.42L/h, no need for oil filter screen Working pressure is 3 bar: 0.5mm diameter, liquid water flow is 4 L/H; 0.8mm diameter, liquid water flow is 6 L/H; 1.0mm diameter, liquid water flow is 8 L/H; 1.5mm in diameter, the liquid water flow is 11L/H; 2.0mm diameter, liquid water flow is 14L/H; 2.5mm in diameter, the liquid water flow is 17L/H; 3.0mm diameter, liquid water flow is 20L/H; 3.5mm diameter, liquid water flow is 23L/H; 4.0mm diameter, liquid water flow is 26L/H; The siphon height is 30cm, and the spray angle is 15-45 degree. Kindly get noticed above data is water base for reference Test: Normally the working pressure is 3 bar, for the 1.00mm version, the liquid waste is 10L/H. For the 2.0mm version, the liquid waste is 19L/H. For the 3.0mm version, the liquid waste is 28L/H. Tolerance capacity is ± 10%. The siphon height is 30cm, and the spray angle is 45 degree. Kindly be noted above data is water basis for reference, if you use another liquid, you can calculate this by density ratio. Installation: The air compressor must be able to deliver at least 10% more air than the specified values. All fuel and air connections must be tightened. If there are leaks, especially in the fuel line, it will have an adverse effect on the lift characteristics. The nozzle will flow in either horizontal or vertical position. The distance lift for a vertical line mounted nozzle is measured from the liquid level to the end (face) of the nozzle. Distance elevator for horizontal mounting is shown in the installation drawing. If the combustion application does not allow the use of a constant level of the device, excellent spray characteristics can be achieved using a fuel metering pump and an air compressor. It is also possible to operate the nozzle in a system that uses closed pressurized air pressure for both lift and atomization of the fuel. Payment safe payment via paypal Shipping Free Worldwide Shipping Return 30 Day's returns